Kenmore 9990 refrigerator water filters are essential for ensuring that the water you drink and use in your home is clean and safe. Over time, these filters can become clogged and less effective, so it's important to know how to replace them. In this post, we'll guide you through the steps to replace your Kenmore 9990 refrigerator water filter.
Step 1: Determine the Type of Filter You Need There are two types of Kenmore 9990 refrigerator water filters: the 9990 and the 9990P. Make sure you have the correct type of filter before beginning the replacement process.
Step 2: Turn Off the Water Supply Before replacing the filter, you'll need to turn off the water supply to the refrigerator. Locate the shut-off valve near the refrigerator and turn it off.
Step 3: Remove the Old Filter The Kenmore 9990 refrigerator water filter is typically located in the top right corner of the refrigerator compartment. To remove the old filter, turn it counterclockwise until it unlocks and then pull it straight out.
Step 4: Prepare the New Filter Remove the new filter from its packaging and remove the protective coverings from the o-rings. Next, align the tabs on the filter with the slots in the filter housing and push it in. Turn the filter clockwise until it locks into place.
Step 5: Flush the New Filter Run water through the new filter for approximately 5 minutes to flush out any air or impurities. This will ensure that your water is clean and fresh.
Step 6: Turn On the Water Supply Once you've flushed the new filter, turn the water supply back on and check for leaks. If there are no leaks, you're done!
Replacing your Kenmore 9990 refrigerator water filter is a simple process that will ensure that your family has access to clean and safe drinking water. Remember to replace your filter every six months to ensure optimal performance.
If you're in need of a replacement Kenmore 9990 refrigerator water filter, visit our website at www.suemez.com. We offer a wide selection of high-quality water filters at affordable prices.